Coolant Hose (Bleeder Valve to 1.5" Coolant Pipe) [Early Vanagon] Moldings 3 - Remove liner (careful

3 - Remove liner (careful not to touch sticky side of film)

• Other heather colors are 52% cotton

Install notes: This kit comes standard with two sender gaskets

which was just before New Years Day

check out this heavy duty Mann filter designed specifically for "Severe Service in Dusty Regions

Coolant Hose (Bleeder Valve to 1.5" Coolant Pipe) [Early Vanagon] Moldings 3 - Remove liner (carefulThis hose connects the bleeder valve housing to the 1. 5" diameter coolant feed pipe. Fits: 1983 85 Vanagon with 1900cc waterboxer cooling system when upgraded with 1. 5" outside diameter cooling pipes. Will NOT fit the earlier 1. 25" diameter cooling pipes. A note on silicone hoses: GoWesty does not offer a silicone version of this hose. If a standard rubber hose is not available, we will at times bring in a silicone substitute. However, there is no