2052 PLUNGE ROUNDOVER BIT Workspace Organization Each set of 5 teeth

Each set of 5 teeth is separated by a large gullet

workpiece end support and a safety guard to protect users from sparks produced during end sanding

and elastic loops

Rockler Bench Cookie Finishing Cones lift your project off your bench with minimal surface contact

flexible and free of sticky residue

2052 PLUNGE ROUNDOVER BIT Workspace Organization Each set of 5 teeth1 4"SH, 1 4"R, 3 4"LD, 1 4"SD Product Description Plunge Roundovers can cut a flat bottom while providing that traditional roundover edge. These bits can also be used to cut out your project, leaving only the traditional roundover edge on the side of your workpiece.